|
|
Post by oldyote on Aug 31, 2013 8:18:21 GMT -5
|
|
|
|
Post by white316 on Aug 31, 2013 22:44:02 GMT -5
They look good.
|
|
|
|
Post by oldyote on Sept 22, 2013 21:20:47 GMT -5
|
|
|
|
Post by oldyote on Sept 22, 2013 21:26:00 GMT -5
 . |
|
|
|
Post by oldyote on Sept 22, 2013 21:30:52 GMT -5
Finally finished my rat boards and belly sticks. The belly Stiks I just cut them out of the 3/8 left overs from the boards. I cut them 1/2 " wide on the table saw then used the belt sander to taper them to about 1/4" -to the 1/2 in about 2/3 rds the legnth of the 24 inch stick.
|
|
|
|
Post by wolf1199 on Sept 23, 2013 7:38:08 GMT -5
looking good. How is your rat population this year?
|
|
|
|
Post by oldyote on Sept 23, 2013 11:43:07 GMT -5
We are infested! Lol. There is rats in every pot hole. Thanks to the record amounts of snow last year I think most lived the winter. And on a plus size there should be a lot more bigger rats instead of all yearlings. Well I hope anyways.
|
|
|
|
Post by wolf1199 on Sept 23, 2013 21:52:24 GMT -5
Well there you go, a millionaire in the making this year. Best of luck to you bud this fall. Are rats so far our poor. Very little sign so far.
|
|
|
|
Post by wolf1199 on Sept 23, 2013 21:58:02 GMT -5
Oldyote beg my pardon but I was just looking at your rat boards again. I see you don't taper your edges. If I may say so you are loosing size due to thickness. Just an incite from my years gone by.?
|
|
|
|
Post by oldyote on Sept 24, 2013 6:14:39 GMT -5
Ok maybe I am not done? They are all planed down to 3/8" And they are rounded but not much of a taper .How thin should they be on the outside edges?
|
|
|
|
Post by oldyote on Sept 25, 2013 17:20:35 GMT -5
Well there you go, a millionaire in the making this year. Best of luck to you bud this fall. Are rats so far our poor. Very little sign so far. more liks a hundredaire! |
|
. Had a heck of a time trying to decide on a nose shape on the rats. Made them to nafa specs but none that gave an inch by inch measurement like they do for the larger boards. Ended up useing a wire one for the nose template. 
